Chief XSM1U Handbuch PDF herunterladen (Seite 11)

Installation Instructions XSM1U/XTM1U

IMPORTANT ! : (XSM1U Only) Completely extend bottom of

interface brackets (by pulling downward) to set interface

brackets in SERVICE position before hanging on top rail. (See

Figure 11)

2. Hang screen onto the top rail of the mount (Z). (See Figure 12)

• XSM1U: Hang top hook of interface brackets (V and

W) onto the top rail of the mount (Z). (See Figure 12)

• XTM1U: Move latch on top of interface bracket to

OPEN position and hang top hook of interface brackets

(X and Y) onto the top rail of the mount (Z). (See

Figure 12)

NOTE: The screen initially installs into the "service mode" to

allow easy cable access.

3. Adjust screen and rails to desired viewing position, and

route cables between wall and rails.

CAUTION: PINCH POINTS! Keep fingers, hands and

cables out of pinch point areas.

4. Fasten bottom of screen to mount:

• XSM1U - Open latch by pushing bottom of interface

bracket up to OPEN position, latching interface

brackets to lower rail, and then push up from bottom of

interface bracket again until the interface bracket is in

CLOSED position. (See Figure 11) and (See Figure 12)

• XTM1U - Pull downward on the pull cords and swing

inward toward mount, latching interface brackets to

lower rail and fastening bottom of screen to the mount.

(See Figure 12)

Figure 11

XTM1U Only:

Attach end of pull cord (a magnet) to mount so

it does not extend beyond bottom of screen. (See Figure 12)

Latch in

SERVICE

position

Latch in

OPEN

position

Latch in

CLOSED

position

Figure 12

Top

Hook

XSM1U

XTM1U

Latch in

Pull

cords

OPEN

position

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Chief XSM1U Handbuch Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flachbildschirmhalterungen Chief XSM1U