Chief PNRUB-G Handbuch PDF herunterladen (Seite 7)

Installation Instructions PNR Series

Installing Mount to Wall

WARNING: IMPROPER INSTALLATION CAN LEAD TO

MOUNT FALLING CAUSING SERIOUS PERSONAL

INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s

responsibility to make sure the structure to which the mount

is being installed is capable of supporting five times the

combined weight of the mount and all attachments.

NOTE: The following instructions assume a suitable mounting

structure and surface exists prior to installation.

CAUTION: To avoid personal injury, use an assistant when

lifting, lowering or holding PNR during installation.

1. Determine mounting location taking into consideration

display size and PNR’s range of movement.

2. Using a stud sensor locate two wood studs 16” on center.

(See Figure 1)

Figure 1

3. Place and level mount against wall, aligning mounting holes

in upper and lower wall channels with studs. (See Figure 1)

4. Mark four mounting holes making sure mounting holes are

located as close as possible to center of studs.

(See Figure 1)

5. Drill four 7/32" pilot holes where the mounting holes were

marked. (See Figure 1)

6. Partially install two 5/16" x 3-1/2" lag bolts (H) into upper

pilot holes. DO NOT tighten at this time. (See Figure 2)

7. Align mounting holes in upper wall channel with lag bolts,

and hang mount on lag bolts.

8. Adjust mount lateral position left until lag bolts are seated in

mounting slots in upper wall channel. (See Figure 2)

9. Place two installation washers (G) over two lag bolts (H).

(See Figure 2)

10. Install two 5/16" x 3-1/2" lag bolts (H) through mounting holes

in lower wall channel and into pilot holes. (See Figure 2)

11. Place two installation washers (G) over two lag bolts (H).

(See Figure 2)

12. Tighten all hardware. DO NOT over tighten!

Figure 2

Adjusting PNR Height

NOTE: Height adjustment range up to 1.08 inches.

1. Check PNR for the desired height. If needed, use the

adjustment wrench (E) to adjust the PNR height. (See

Figure 3)

• Turn adjustment nut clockwise to lower the unit height,

• Turn adjustment nut counterclockwise to raise the unit

height.

Figure 3

x 4

(H) x 4

(G) x 2

Adjustment nut

Lower

Raise

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Chief PNRUB-G Handbuch Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Flachbildschirmhalterungen Chief PNRUB-G